Liquid Stripe Exhaust System for Seamed Can Bodymakers
Harbridge's patented exhaust system is designed to lower maintenance time and reduce problems caused by inner or outer overspray on can welding lines. They have proven results by lower tooling wear and decreased beader and flanger maintenance.
Over 150 of these systems are now in operation worldwide.
With the higher solids content in coatings, and ever increasing line speeds, some of our customers have opted for auxiliary stripe hoods, cure enclosures, burner mounts, and accelerator hoods for maximum heat, fume, and odor control.
Our exhaust system features:
Hi-Efficiency Extraction
- Overspray capture
- 'Tunnel' evacuation
- VH Model developed for high solids content and improved extraction
- Multi-stage, high efficiency filters assure minimum carryover or fouling of exit ducts and fan
- Minimum load on 'VOC' incineration system when required
- Minimum make-up air requirements
Minimum Operating Costs
- Progressive filter staging (filters used 3 times)
- Replacement filter media at low cost
- Special fan selection for reduced maintenance and power requirements
- Harbridge E-Z-AX® design simplifies clean-up. Standard unit has few parts, with the majority being detatchable without tools
- Stainless steel; easiest clean-up, no painting
Technical Support
- Substantial planning, installation, operation and maintenance manual
- Plant survey services
- Site installation and start-up standard
- Numerous options and auxiliary systems available Technical updates for registered systems
|
 |
